Ingemann Packaging A/S

The new Ingemann plastic bag dispenser is designed and manufactured in Denmark. Along with the aluminum tubes and polypropylene holders, the handsome and modern design of the dispenser will complement any contemporary shop fitting. While being very light weight, the dispenser is made from re-enforced Polypropylene, and injection molded and cast in one piece for extra-ordinary endurance and stability. In standard version it is available in a variety of colors, but also modified colors are possible to match any requirement from the retail stores.

The PMO is a highly flexible display unit and consists of a round floor base filled with dried sand to provide stability. Two different heights is possible, either with a height extension and a single dispenser or as a double-dispenser solution combined with the BMD holder. In this case the height extension should not be used.

The PMO is also perfect for outdoor use as it is easy to move back indoor again at closing time.

The VHR can be attached on to edges of either tables or counters, either in a vertical or horizontal position, or to surfaces where screws may not or cannot be used. Furthermore, it can be adjusted to different thicknesses of surface.